Sony STR-6050

A $279.50 receiver that a lab guessed cost $120 more — the understatement was the whole point.

Overview

Sony's own advertising for the STR-6050 leaned on a single anecdote, and it's a good one: when Hirsch-Houck Laboratories received the receiver for testing, they didn't know the price. They listened first, guessed from the performance, and came in about $120 high. Sony ran that story as a full-page ad in Audio (April 1970, p.49) and High Fidelity (April 1970, p.39), billing the gap as its "understatement-of-the-year award." Whether you take the ad at face value or not, the number it hangs on is real: $279.50 for an all-silicon-transistor FM stereo/FM-AM receiver at the turn of the 1970s.

The circuit is where the money went. The service documentation lists a semiconductor complement of 46 all-silicon transistors — including three FETs — plus 34 diodes. That's not a parts count chosen for a brochure; it's the signature of a tuner front end built around FETs. In the AM section, a pair of FETs (Q301 and Q302) form a cascaded amplifier, and the manual makes a point of the AGC circuit riding on the FET to pull a large figure of merit out of AM reception — the band most receivers of the period treated as an afterthought. The FM side is just as deliberate: the multiplex decoder uses a balanced-bridge diode demodulator (D405 through D408) chosen specifically to cancel residual 38 kHz and 19 kHz components and their harmonics, with a twin-T filter cleaning up what's left of the carrier. There's even a pre-noise amplifier (Q404) that mutes the stereo indicator on interstation noise so the light doesn't flicker on garbage.

Power is rated at 75 watts per channel into 8 ohms, both channels driven, IHF — a dynamic power figure rather than a continuous one, so read it in the context of early-'70s rating conventions. The amplifier section uses a negative-feedback topology the manual credits with stable operation across temperature change and good low-frequency amplification, and it feeds a REC OUT terminal for taping. One thing worth knowing before you open one up: the AC balance adjustment (RV701, 100 kΩ·B) is genuinely critical — the service notes warn that a misadjusted balance will produce serious harmonic distortion at high levels, so anyone recapping or servicing the output stage needs a scope and the procedure in hand.

The physical build is serviceable in the way gear from this era was. The front panel is a vertical assembly carrying the glass dial, switches, tuning meter, and pilot lamps, and it comes off after the cover and knobs, two screws per side, unhooking the dial cord from the pointer tab (mark the pointer position on the cord first — the manual says so, and it says so for a reason). Lamps are a maintenance item: the meter lamp slides off its bracket and unscrews, while the stereo lamp lives on the tuning meter holder under the bottom plate and is cemented in place, requiring a drop of cement solvent and a pair of tweezers. None of this is difficult; all of it is fiddly.

Collectors chasing the STR-6050 are usually chasing that price-to-performance story and the FET tuner that backs it up. The ad copy is easy to find and easy to dismiss — it's marketing, and Sony wrote it. The reason the receiver still gets talked about is that an independent lab, working blind, put its performance well above its sticker. That's a more useful endorsement than any slogan, and it's the one the archive would point a buyer toward.

eBay Listings

SHOP SONY STR-6050 RECEIVERS ON EBAY

As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.

Related Models