Sony WRT-808A
A plug-in UHF transmitter with a switchable 50/10 mW output. It let a broadcast crew swap mics without swapping transmitters.
Overview
The WRT-808A is a plug-in UHF wireless transmitter built to accept any dynamic microphone with an XLR connector. That connector is the whole point. This is not a bodypack tethered to a lav. It's the module that sits in-line between a handheld mic and the cable, and it turns whatever dynamic mic a crew already owns into a wireless mic. For news and field work that means the transmitter adapts to the mic, not the other way around.
It runs on two AA batteries and has a battery-level indicator, a level control, and an AF/Peak indicator that shows the condition of the audio input level. A low-battery alarm works with compatible receivers, so the talent isn't left guessing when the cells are getting soft. None of this makes a spec sheet look exciting.
The RF side is where the 808A separates itself from its siblings. It tunes across 98 selectable channels. The 800 Series as a whole offers 102, but Sony's own documentation notes that 98 are selectable when using the WRT-808A specifically. The range runs 792.250 MHz to 805.250 MHz, with the 68/66/64 band variants covering 794-806, 782-794, and 770-782 MHz respectively. Tuning is handled by a crystal-controlled PLL synthesizer, emission type 110KF3E, with ±5 kHz reference deviation at -60 dBV, 1 kHz input.
The big difference from the WRT-807A and WRT-805A is the output stage. Both siblings put out a fixed 10 mW into a 50 Ω load. The WRT-808A offers 50 mW or 10 mW, selectable. Use more power for range when the venue is difficult, or less to conserve battery and stay inside tighter coordination when the situation allows. The 808A also uses an internal antenna rather than the quarter-wave wire antenna of the other two. Its attenuator is a continuous 0 to 50 dB pad, where the 807A and 805A have a 21 dB pad in 3 dB steps. Input level is -60 dBV to -10 dBV at 1 kHz modulation.
Frequency response is quoted at 70 Hz to 15,000 Hz, and signal-to-noise is more than 57 dB A-weighted. Those aren't the widest or quietest numbers around, but they're the numbers Sony committed to for this transmitter, and they're fine for speech and general program audio.
The 800 Series was engineered to escape the congestion of the VHF band, with its walkie-talkies, CB radios, and general hash. Sony's literature frames the move to 800 MHz UHF as the reason the system can be re-coordinated on the fly. Interference changes from venue to venue and night to night, so the frequency-agile tuning is the first line of defense. The 808A's 98 channels are the practical side of that idea.
Pro Audio Review (June 2002, p.53) reported that Detroit NBC affiliate WDIV-TV paired WRT-808A transmitters with WRR-855 UHF synthesized tuners for news gathering. A staffer noted the need for gear reliable enough for on-the-run interviews where there's only seconds to capture audio. The same issue (p.51) quoted Logan Productions, a business-theater and video outfit, saying it had moved entirely to Sony UHF wireless and that the 808A transmitters "work with any microphone." Jim Logan told the magazine his company evaluated systems from several manufacturers and consistently found the Sony system outperformed the others. That's a user's verdict, not a lab measurement.
Anyone chasing these today should know the practical limits: two AA cells, a low-battery alarm that needs a compatible receiver to be useful, and a frequency plan tied to the 792-806 MHz neighborhood. The 50/10 mW switch and continuous attenuator make the 808A the most flexible of the three siblings, which is why it tends to be the one people look for when assembling a period-correct 800 Series rig. It's a tool, not a studio condenser.
eBay Listings
As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.