Roland TR-808 (1980–)
A 5 kg slab of steel and plastic, and the rhythm machine Roland couldn't give away - until the whole world started buying beats by the bar.
Overview
The TR-808 is a rhythm machine in a 508 mm wide, 305 mm deep, 110 mm tall chassis that weighs 5 kg. It is heavier than it looks in photos, and it draws just 8 watts from the wall. As EQ Magazine (September 2007, p.76) notes, it is an historic piece of gear that Roland introduced in late 1980. It is a fully analog percussion synthesizer, and every sound is generated in real time rather than played back from memory.
The voice architecture is where the machine earns its reputation. Each voice is a discrete circuit rather than a sample slot, and the trigger system is more elegant than it first appears. According to the service documentation, the CPU generates a common trigger pulse that is applied in parallel to the gates of all sound generators, while instrument data — which voice should fire — is supplied independently from dedicated ports. The gate ANDs the two signals, and a voice sounds only when both are present. Because the peak value of that trigger signal is proportional to the common trig pulse, accent data can change the amplitude of every hit at once. The accent circuit itself is built from Q31 through Q34, and the manual is specific about the behavior: with no accent data, the base of Q32 sits at roughly +5V and the trigger amplitude lands near 4V. With accent data present, that voltage swings between 5V and 15V depending on the VR3 setting, producing trig pulses of approximately 4–14V. That is the whole trick behind the 808's accent — a variable trigger amplitude, not a separate envelope. For the cymbal, open hat, closed hat, and cowbell voices, the trig variation range is deliberately narrowed to 7V–14V by half of IC2 on the voicing board, a design choice the manual attributes to improving the signal-to-noise ratio on those voices.
The sequencer memory is small by modern standards. Rhythm storage capacity runs 1-32 steps per measure across 64 measures and 12 tracks, with a tempo variable range of 40-300 BPM. Four CMOS RAMs, each 1K by 4-bit, hold the pattern data. The manual notes that chips are selected when the upper two bits of PE data decoded by IC5 are enabled by pulses from PI-1. Panel control settings are read by CPU interrupt: a Buffer & gate turns on from a PH signal, statuses are read through PA, and the step and function switch states are read every fourth interrupt rather than on every pass. It is a scanning design, not a direct-read one, and it is documented well enough that a technician can trace a dead button back to a specific port.
The output section is flexible for a 1980 drum machine. Master output is specified at Hi 6V p-p into 1KΩ or Lo 0.6V p-p into 3KΩ, measured with voices at the red mark and AC at fully clockwise. Multi output impedance is 1KΩ, and there is a trigger output rated at +15V, 20ms into 1KΩ, wired for CB/CP(MA)/AC. Accent level is adjustable from 0dB to 10dB.
The TR-808 is a computer-controlled instrument, and the CPU governs almost every process up to the generation of trigger pulses. The manual's troubleshooting guidance is blunt. Because most circuits function under CPU control, faults are more often found in peripheral circuits, and the CPU should be replaced last of all.
eBay Listings
As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.