Tektronix SG-505

A TM 500 plug-in oscillator that claims the lowest residual distortion of any oscillator on the market — and the paperwork backs up why that mattered.

Overview

The SG-505 is an oscillator built as a plug-in for Tektronix's TM 500 mainframe system, covering a sine wave range of 10 Hz to 100 kHz. That much is confirmed by the Studio Sound equipment directory, which lists it plainly alongside its siblings: the AA-501 bandpass filter/amplifier, the SG-502 oscillator covering 5 Hz to 500 kHz with both sine and square waves, and the 5L4N spectrum analyzer. The SG-505 sits in that family as the lower-frequency, sine-only member — a specialist rather than a generalist, and the one Tektronix paired with its distortion analyzer.

That pairing is the whole story of this instrument. Tektronix's own advertising billed the SG-505 and the AA-501 Distortion Analyzer as a matched set, and the numbers in that copy are striking: a sine wave output with less than 0.0008% THD, described as the lowest residual distortion of any oscillator then on the market. When the two plug-ins worked in tandem, Tektronix claimed the combination delivered the lowest harmonic distortion plus noise rating in the entire industry at 0.0025%. DB Magazine (March 1981, p.55) ran the launch material describing the pair as giving "the quickest distortion measurements ever," with the analyzer's digital processing locking onto test signals, setting levels, and adjusting the notch filter for nulling automatically. Whether or not one accepts the superlatives at face value, the intent is clear: this was a measurement system, not a standalone signal source, and the oscillator's job was to be so clean that anything the analyzer found could be attributed to the device under test rather than to the test gear.

The TM 500 architecture is what makes the SG-505 interesting to collectors today. According to Tektronix's own literature, the plug-ins could be installed in any of five mainframes — rackmount, bench, and portable among them — and, notably, the AA-501 and SG-505 could be separated and still used as a team even when physically apart. That configurability was the selling point of the whole TM 500 line, which the company advertised as supporting over forty other plug-ins. For a broadcast engineer, that meant one mainframe could host an oscillator, a distortion analyzer, and whatever else the bench required, swapped as needed.

There was also a balanced variant. Tektronix introduced an SG-505 Option 2, pitched specifically at studio and transmitter-site use, offering balanced high-level output. DB Magazine (October 1982, p.61) carried the announcement, again leading with the sub-0.0008% THD figure and the tandem operation with the AA-501. The Option 2 version matters because balanced I/O is what you need when you're patching into professional console and transmission chains rather than a bench setup — an unbalanced oscillator is fine on the test bench, less so at a transmitter site.

The instrument also had a life beyond the catalog page. The SBE Monthly Log records Tektronix sales engineer George Anderson giving a chapter presentation on the AA-501/SG-505 combination to the Northeastern Pennsylvania chapter, and a Milwaukee meeting where Tektronix staff presented on spectrum analysis. That's the kind of footprint a working broadcast tool leaves — demoed at chapter meetings, specified into stations, used until something cheaper or newer came along.

eBay Listings

TEKTRONIX SG-505 OSCILLATORS ON EBAY

As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.

Related Models