Shure SM7A

The broadcast dynamic that hides four microphones inside one — and a humbucking coil that finally made it studio-safe.

Overview

The SM7A is the quiet fix to a very specific problem. Its predecessor, the SM7, was already a broadcast staple — a wide, smooth dynamic built for voices — but it had a reputation for picking up electromagnetic hum from computer monitors, neon lights, and the general electrical swamp of a working studio. Shure's answer in the SM7A was a redesigned humbucking coil, and EQ Magazine (July 1999, p.66) reported that this shielding was the central change, providing broadband rejection of exactly the kind of interference that had made engineers reach for a different mic near a CRT. That single revision is the whole reason the letter "A" exists on the badge.

The capsule keeps the same smooth, wide-ranging response and natural sound reproduction as the original SM7, per that same EQ preview — a 50 Hz to 20 kHz range that, for a dynamic, is unusually extended at the top. Shure's own literature for the period quoted a slightly tighter 40 Hz to 16 kHz figure, so treat the extremes as approximate rather than gospel; the character is what matters, and the character is a big, unhyped low end with a controlled top that sits a vocal in a mix without the sibilance fight a condenser can start.

What makes the SM7A genuinely unusual is that it is four microphones in one. Bass roll-off and midrange emphasis controls give a choice of four different response curves, so a single mic can go from flat and full-range to a thin, presence-forward setting that cuts through a dense mix. DB Magazine (October 1983, p.2), writing about the SM7 it descended from, made the same point plainly — the design was really four microphones rolled into one, built so broadcast engineers could handle a wide variety of voices with a single tool. Owners tend to find one curve they love and never touch the switches again, but the flexibility is real and it is the reason these mics turn up in front of everything from screaming guitar cabs to whispered narration.

The mechanical package is where the SM7A earns its keep in a working room. An internal air-suspension shock mount isolates the cartridge from mechanical vibration, and the integral foam windscreen damps wind, boom noise, and breath pops — the stuff that ruins a close-miked take. Shure's patented air-suspension design was already being praised in the SM7 era for cutting down vibration effects in the studio, and the SM7A carries that forward unchanged. The locking yoke mount lets you set an angle and trust it to stay put, which sounds trivial until you have watched a mic droop mid-session.

It is also heavy — 27 oz, per Shure's spec sheet — and that weight is a feature, not an oversight. A heavy dynamic body resists the sympathetic vibrations that lighter mics pick up, and it stays put on a boom. The trade-off is that a cheap, spindly stand will sag under it, so plan on a real stand. The symmetrical cardioid pattern is tight enough to reject the room behind it without being so narrow that the talent has to stay locked in place, which is why the SM7 family became the default for voice-over and broadcast work.

New, the SM7A listed at $584.50 according to Shure's distributor materials, with a spare windscreen running $15.50 — a reminder that even the foam is a consumable on a mic this heavily used. That price put it firmly in professional territory when it was current, and it was never a budget piece. Collectors note that the SM7A occupies an odd spot in the lineage: it is the transitional model between the original SM7 and the later SM7B, and because its defining feature was an internal electrical fix rather than a cosmetic one, it is easy to mistake for its siblings on a shelf. Buyers should confirm the model marking rather than trusting a photo.

For anyone chasing one today, the practical cautions are the usual ones for a broadcast dynamic: the foam windscreen degrades and crumbles with age, and a replacement is cheap insurance; the switches can get scratchy or intermittent after decades of use and benefit from a cleaning. The humbucking coil that defines the model is not a user-serviceable part, so a unit with a hum problem is a repair job, not a tweak. None of that is exotic — this is a rugged, repairable microphone — but it is the difference between a $584 list mic that still works and a paperweight.

What the SM7A is not is a condenser, and it never pretended to be. Studio Sound (February 2000, p.71) noted that the dynamic mic had continued to soldier on, serving a variety of applications even as condensers soaked up most of the attention — a fair summary of the SM7A's position. It does not deliver the airy detail of a large-diaphragm condenser, and it will not flatter a source that needs sparkle. What it does is deliver a natural, unhyped voice with excellent rejection and almost no handling noise, in a package that survives being knocked around a control room. For speech, for loud guitar, for anything where the room is fighting you, that trade is usually the right one.

eBay Listings

Shop Shure SM7A on eBay

As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.

Related Models