Kenwood TS-700S (1977–1978)

Eleven kilograms of 1977 Japanese VHF, built like a desk and tuned like a dial should be.

Overview

The TS-700S is what a two-meter base station looked like before synthesized rigs ate the market: a 278 × 124 × 320 mm box weighing in at 11 kg, with a continuous VFO, a digital readout, and a mode switch that runs AM, FM, SSB, and CW. Kenwood built it in Japan for 1977 and 1978 and then discontinued it — a short run, which is part of why it turns up less often than the later all-mode VHF gear collectors chase. The fact sheet identifies it as an amateur VHF transceiver; RigReference calls it a desktop VHF transceiver, and it reads as exactly that — the kind of radio that lived on a shelf, not in a go-bag.

Frequency coverage depended on where you bought it. European units were locked to 144–146 MHz on both transmit and receive; USA units covered 144–148 MHz. Tuning is continuous rather than stepped, which is the whole point of the VFO on this generation of gear — owners of these older analog-tuned rigs tend to describe the feel of a good VFO as something later synthesized radios never quite replicated, and the TS-700S is squarely in that camp. What the fact sheet can confirm is the mechanism: continuous tuning, no step size, no memories in the modern sense.

Power is where the TS-700S shows its age in an interesting way. It will run from mains — 110–120 or 220–240 VAC — or from 12–16 VDC, drawing 1.2 A on receive at 13.8 VDC (48 W at mains) and a maximum of 4 A on transmit at 13.8 VDC (max 98 W at mains). The 12–16 VDC input makes it a legitimate field or emergency rig if you can live with the weight, though 11 kg is a lot of transceiver to carry to a hilltop.

Key Features

Continuous VFO Tuning with Digital Readout

The tuning is continuous — no channel steps, no synthesized lock — paired with a digital readout, which was still a premium touch in a 1977 VHF rig. The fact sheet lists frequency stability at within ±2 kHz during the first hour after a one-minute warmup, tightening to within 150 Hz during any 30-minute period thereafter. That's a spec worth reading carefully: this is a radio that wants a few minutes to settle before you trust the dial, and then holds reasonably well once it's warm. The optional crystal channels — 11 of them, XTAL controlled — give operators a way to park on a known frequency without trusting the VFO, which is the kind of belt-and-suspenders design that defined the era.

Four Modes Across a Mode-Specific Receiver

The receiver isn't one topology — it's two, selected by mode. AM, SSB, and CW run through a single-conversion superheterodyne with a 10.7 MHz IF. FM switches to double conversion, with a 10.7 MHz first IF and a 455 kHz second IF. That's a deliberate design choice, not a cost-saving compromise, and it shows up in the sensitivity numbers: 1 µV for AM at 10 dB (S+N)/N, 0.25 µV for SSB/CW at the same standard, and 0.4 µV for FM at 20 dB noise quieting. Squelch threshold sits at 0.25 µV. Selectivity follows the mode split too — 2.4 kHz at −6 dB and 4.8 kHz at −60 dB for AM/SSB/CW, versus 12 kHz and 24 kHz for FM. Image rejection is quoted at 70 dB.

10 W on FM, SSB, and CW — 3 W on AM

Transmit power is 10 W on FM, SSB (PEP), and CW, dropping to 1 W on FM when you switch to low power. AM tops out at 3 W. The fact sheet doesn't state low-power values for AM, SSB, or CW, so collectors should treat those as unknown rather than assume they mirror the FM 1 W setting. Modulation is variable reactance frequency shift on FM, balanced modulation on SSB, and low power modulation on AM. Maximum FM deviation is factory set at ±5 kHz, and spurious emissions are quoted at better than −60 dB. The microphone input is a 500-ohm, 4-pin male locking ring jack — the period-correct connector that makes finding a working original mic a small project in itself.

Repeater Shift, Tone, and Operator Conveniences

Repeater offset is fixed at −600 kHz, and European units carried the 1750 Hz repeater tone — the access tone that defined European repeater work in this era. The feature list also includes VOX, noise blanker, and RIT, plus a digital readout. The antenna connection is a 50-ohm SO-239, and the external speaker output is a 3.5 mm minijack rated at 8 ohms, with 2 W of AF output at 10% distortion. None of this is exotic by later standards; all of it was serious kit in 1977.

Historical Context

Kenwood built the TS-700S in Japan for 1977 and 1978 and discontinued it after that short run. The factory accessory list tells you how the radio was meant to be used: the HC-2, HS-5, MC-50, SP-70, VFO-700S, a ham clock, headphones, a desk microphone, an external speaker, and a remote VFO. That's a base-station ecosystem, not a mobile package — the VFO-700S in particular signals that Kenwood expected operators to run the TS-700S as a fixed installation with outboard gear. The radio was also sold under the TRIO name, which collectors will see on some listings and should not mistake for a different product.

A related designation, TS-700SP, appears alongside the TS-700S in service-manual listings — the two share documentation — but the sources don't state the relationship between them, so collectors should treat them as distinct designations until better documentation surfaces. A separate model, the TS-700A, also appears in period material and should not be conflated with the TS-700S.

Collectibility & Value

Market pricing for the TS-700S isn't well documented. Units turn up on eBay, but no reliable price figures were captured, so anyone buying should treat the market as thin and price accordingly rather than trusting a single completed listing. The documentation situation is better than the pricing situation: a user manual exists, and a full service manual runs 73 pages in the printed version (74 pages per one manual archive), with a parts list and a troubleshooting guide included. Used spare parts — an original S meter, for example — circulate, which matters on a radio this age.

The repair reality is worth stating plainly. Owner commentary on these 40-plus-year-old units notes that they are not simple to service, and untested examples are frequently sold as junk rather than as working radios. Buyers should assume a TS-700S needs attention before it's trustworthy on the air, and should weigh the availability of that 73-page service manual as one of the model's genuine strengths. The VFO tuning remains the emotional draw — the smooth analog feel that owners of this generation of gear consistently single out — but the digital readout, the mode-specific receiver, and the 11 kg chassis are what make it a proper base station rather than a novelty.

eBay Listings

Shop Kenwood TS-700S on eBay

As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.

Related Models