General Electric 12AU7
A twin-triode workhorse that broadcast engineers leaned on for everything from gain stages to switching pulses — and that repair benches still reach for today.
Overview
The 12AU7 is a dual triode — two independent triode sections sealed in a single glass envelope — and General Electric's version of the type shows up again and again in the period engineering literature, not as a headline component but as the quiet, dependable block that makes the rest of a circuit work. The most detailed documentation of the tube in action comes from broadcast-engineering write-ups of the late 1950s, where the 12AU7 appears in output stages, driver stages, and switching circuits alike. What emerges from those pages is a portrait of a tube chosen for versatility rather than for any single spectacular number.
In Dwight Harkins' design for an automatic audio level control amplifier, the signal path runs from an input transformer through a variable-gain 6386 stage into a 12AT7 push-pull voltage amplifier, which then feeds push-pull parallel 12AU7 output tubes. That placement is telling: the 12AU7 sections are doing the final current delivery, paralleled to share the load, in a unit built to ride gain automatically across AM, FM, or TV program material. The same article's circuit diagram lists the tube lineup — a 6386, a 12AT7, two 12AU7s, a 6AL5, and a 5Y3 — so the 12AU7 accounts for two of the six tubes in the chassis.
A second design, Ed Miller's automatic fader for a broadcast remote amplifier, uses the 12AU7 in a very different way. There the tube's plate impedance becomes the variable center leg of a "T" pad, with attenuation controlled by grid voltage rather than by a mechanical pot. Miller published a family of plate curves for one section of the 12AU7 with a 390,000-ohm plate load from a 260-volt supply, and reported a change in excess of 15 dB in plate impedance between grid voltages of minus .05 volts and positive .4 volts. He also noted that the plate impedance stays relatively constant over most of the negative grid range, which is why maximum control comes from operating the grid positive — an unusual bias arrangement that limits the plate voltage swing to only a volt or so across several dB of impedance change, reducing control transients and allowing single-ended operation down to lower frequencies.
That same write-up gives a useful sense of the tube's bandwidth in this service. Miller states that with most standard receiving triodes, essentially flat operation can be had from less than 100 cycles to more than 100 kc, with the upper limit set by the tube's plate-to-grid and plate-to-cathode capacitance and by the value of the input leg of the pad. For a tube pressed into service as a voltage-variable attenuator, that is a wide, honest working range.
The 12AU7 also turns up in the switching and synchronization circuitry of the KISW-FM stereophonic broadcast experiments of November 1959. In the transmitting unit, a 12AU7 driver switched the cathodes of the input amplifier, and a 30 kc multivibrator built around a 12AU7 generated the switching pulses, operating the switches through another 12AU7 driver. At the receiving end, two separate switcher units and two driver units were all 12AU7s, controlled by a single 12AU7 multivibrator. The synchronizing chain used additional 12AU7 stages to amplify the recovered 30 kc pulse before feeding it to the receiving multivibrator. In a system where both ends had to run in exact unison, the 12AU7 sections were doing the timing-critical work.
Collectors and repair technicians who deal in broadcast and test gear of this period tend to treat the 12AU7 as a known quantity — a tube that appears so often in period designs that a stash of them is less a collection than a working inventory. The documentation above makes the case for why: the same envelope serves as a paralleled output device, a variable-impedance element, and a pulse generator, and the circuit designers of the day clearly trusted it in all three roles.
eBay Listings
As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.