Collins 300-G
A broadcast transmitter you tune with three motors and a single knob — and it holds its carrier to within ten cycles.
Overview
The first thing that hits you about the 300-G is the door. It's a full-length front door with glass windows, so you can watch the 810 modulator tubes and the 810 RF finals glowing while the thing is on the air. That's not decoration — Collins built the whole transmitter around serviceability, with all tubes reachable from the front and double rear doors opening onto the vertical chassis. The complete cabinet measures 41 inches wide, 29¾ inches deep, and 78 inches high, and it weighs in at roughly 1,370 pounds. This is not gear you move on a whim.
The 300-G is a 250/100-watt AM broadcast transmitter, high-level modulated with a Class B modulator system. Collins' own literature describes it as designed "particularly for high fidelity broadcast service," and the audio path uses a feedback circuit intended to keep distortion low. The RF section will deliver its rated 250 watts into a resistive transmission line load — the manual specifies 70 to 200 ohms in one place and 30 to 250 ohms in another, so treat the load range as broad and check your own documentation before you commit an antenna match.
The frequency story is where the 300-G gets interesting. It's crystal controlled and heat compensated, operating on any single frequency between 540 and 1600 kc, with the crystal frequency matching the desired output frequency. Once you've set the operating frequency, any substantial change may require modification of the output tank circuit capacities and changes to the neutralizing system — this is not a frequency-agile box. Carrier stability is held to within ±10 cycles per second, which for a broadcast transmitter of this class is genuinely tight. Two complete plug-in 40F frequency control units ship with each equipment, and a front-panel switch on the 33Q unit lets you select either oscillator; the one not in operation can be pulled for repair or adjustment while the other keeps you on the air. That redundancy is the kind of thing you only appreciate when a crystal oven dies at 2 a.m.
Tuning is motor driven. Three separate tuning motors handle the 307 plate circuit, the power amplifier plate tuning, and the antenna loading network. Two of the motors drive a flexible steel ribbon that varies the position of a slug in the network coil of their respective circuit; the third drives the rotor of a tuning capacitor in the intermediate amplifier stage. All of it is controlled from the front panel by a single tuning control knob working in concert with a selective tuning selector switch. For a transmitter this size, that's an elegant solution — you're not reaching into a live chassis with a tuning wand.
Audio input is 600 ohms (150 ohms on special order), and full 100% modulation needs +18 dbm, or +8 dbm with the input pad removed. Collins recommended pairing the 300-G with its own 6X line amplifier and monitor, or the 26W-1 limiting amplifier. Frequency response is specified at ±1 db from 30 to 10,000 cps, noise sits more than 60 db below 100% modulation, and distortion stays under 3% up to 95% modulation. Those are respectable numbers for the era, and the ±1 db audio response is the spec that separates a high-fidelity broadcast transmitter from a public-address amp.
Power is 115 volts AC single phase 60 cps, or 208/230 volts AC single phase on a neutral system. Normal operation draws about 1.5 kw at 85% power factor; at 100% modulation with a 400 cps tone the demand rises to roughly 1.7 kw. A voltage regulating transformer keeps filament voltages constant across a ±15% swing in AC line voltage — a feature Collins singled out as special, and one that matters enormously in a station where the line sags every time the compressor kicks on.
Safety is built in rather than bolted on. Magnetic circuit breakers form an integral part of the principal power circuits, serving as both isolation for the major circuits and as an overload device, with switching accomplished in the primary circuits. Every door carries an interlock switch so high voltages are removed before maintenance personnel can get inside. That's the sort of design detail that tells you this was engineered by people who expected it to be serviced by human beings for decades.
The tube complement is a who's-who of mid-century glass: a pair of 6F6 oscillators, a 6L6 isolation buffer, a pair of 807 intermediate amplifiers, a pair of 810 RF amplifiers, a pair of 6J5 first audio tubes, a pair of 6A5G or 6B4G audio drivers, a pair of 810 modulators, six 866A/866 rectifiers, and a pair of OC3/VR105 voltage regulators. That's a lot of bottles to keep in stock, and anyone contemplating one of these today should think hard about tube sourcing before they think about cosmetics.
Environmental ratings are modest but specific: +15°C to +45°C operating temperature, 0 to 95% humidity, and altitude up to 6,000 feet. A ventilating blower at the rear of the cabinet forces air through ducts to the front of the upright chassis, drawing in through spun-glass filters in the rear doors. Those filters need attention — a clogged filter on a transmitter running 810s is a slow death for everything downstream.
One note on the documentation itself: the manual lists the maximum carrier output for satisfactory operation at 275 watts, while the maximum rated carrier power as determined by FCC order is 250 watts. Collins built in a little headroom above the legal rating, which is either reassuring or tempting depending on your relationship with your license.
The plug-in frequency units, the motor-driven tuning, and the front-and-rear door access all point to a design philosophy that assumed the transmitter would outlive several generations of engineers. Whether that's true of any individual unit today depends entirely on how it was stored and whether the transformers and tuning motors survived. The 1,725-pound domestic shipping reality means most of these change hands between people who already know what they're looking at.
eBay Listings
As an eBay Partner, we earn from qualifying purchases. This helps support our independent vintage technology research.